Section 13386 - [Second of two versions] [Effective until 1/1/2026] Ignition interlock devices(a)(1) The department shall certify or cause to be certified ignition interlock devices required by Article 5 (commencing with Section 23575) of Chapter 2 of Division 11.5 and publish a list of approved devices.(2)(A) The department shall ensure that ignition interlock devices that have been certified according to the requirements of this section continue to meet certification requirements. The department may periodically require manufacturers to indicate in writing whether the devices continue to meet certification requirements.(B) The department may use denial of certification, suspension or revocation of certification, or decertification of an ignition interlock device in another state as an indication that the certification requirements are not met, if either of the following apply: (i) The denial of certification, suspension or revocation of certification, or decertification in another state constitutes a violation by the manufacturer of Article 2.55 (commencing with Section 125.00) of Chapter 1 of Division 1 of Title 13 of the California Code of Regulations.(ii) The denial of certification for an ignition interlock device in another state was due to a failure of an ignition interlock device to meet the standards adopted by the regulation set forth in clause (i), specifically Sections 1 and 2 of the model specification for breath alcohol ignition interlock devices, as published by notice in the Federal Register, Vol. 57, No. 67, Tuesday, April 7, 1992, on pages 11774 to 11787, inclusive, or the model specifications for breath alcohol ignition interlock devices, as published by notice in the Federal Register, Vol. 78, No. 89, Wednesday, May 8, 2013, on pages 25489 to 26867, inclusive.(C) Failure to continue to meet certification requirements shall result in suspension or revocation of certification of ignition interlock devices.(b)(1) A manufacturer shall not furnish an installer, service center, technician, or consumer with technology or information that allows a device to be used in a manner that is contrary to the purpose for which it is certified.(2) Upon a violation of paragraph (1), the department shall suspend or revoke the certification of the ignition interlock device that is the subject of that violation.(c) An installer, service center, or technician shall not tamper with, change, or alter the functionality of the device from its certified criteria.(d) The department shall utilize information from an independent, accredited (ISO/IEC 17025) laboratory to certify ignition interlock devices of the manufacturer or manufacturer's agent, in accordance with the guidelines. The cost of certification shall be borne by the manufacturers of ignition interlock devices. If the certification of a device is suspended or revoked, the manufacturer of the device shall be responsible for, and shall bear the cost of, the removal of the device and the replacement of a certified device of the manufacturer or another manufacturer.(e) A model of ignition interlock device shall not be certified unless it meets the accuracy requirements and specifications provided in the guidelines adopted by the National Highway Traffic Safety Administration.(f) All manufacturers of ignition interlock devices that meet the requirements of subdivision (e) and are certified in a manner approved by the department, who intend to market the devices in this state, first shall apply to the department on forms provided by that department. The application shall be accompanied by a fee in an amount not to exceed the amount necessary to cover the reasonable costs incurred by the department in carrying out this section.(g) The department shall ensure that standard forms and procedures are developed for documenting decisions and compliance and communicating results to relevant agencies. These forms shall include all of the following:(1) An "Option to Install," to be sent by the department to all offenders along with the mandatory order of suspension or revocation. This shall include the alternatives available for early license reinstatement with the installation of a functioning, certified ignition interlock device and shall be accompanied by a toll-free telephone number for each manufacturer of a certified ignition interlock device. Information regarding approved installation locations shall be provided to drivers by manufacturers with ignition interlock devices that have been certified in accordance with this section.(2) A "Verification of Installation" to be returned to the department by the offender upon application for reinstatement. Copies shall be provided for the manufacturer or the manufacturer's agent.(3) A "Notice of Noncompliance" and procedures to ensure continued use of the ignition interlock device during the restriction period and to ensure compliance with maintenance requirements. The maintenance period shall be standardized at 60 days to maximize monitoring checks for equipment tampering.(h) The department shall develop rules under which every manufacturer and manufacturer's agent certified by the department to provide ignition interlock devices shall provide a fee schedule to the department of the manufacturer's standard ignition interlock device program costs, stating the standard charges for installation, service and maintenance, and removal of the manufacturer's device, and shall develop a form to be signed by an authorized representative of the manufacturer pursuant to which the manufacturer agrees to provide functioning, certified ignition interlock devices to applicants at the costs described in subdivision (k) of Section 23575.3. The form shall contain an acknowledgment that the failure of the manufacturer, its agents, or authorized installers to comply with subdivision (k) of Section 23575.3 shall result in suspension or revocation of the department's approval for the manufacturer to market ignition interlock devices in this state.(i) A person who manufactures, installs, services, or repairs, or otherwise deals in ignition interlock devices shall not disclose, sell, or transfer to a third party any individually identifiable information pertaining to individuals who are required by law to install a functioning, certified ignition interlock device on a vehicle that he or she operates, except to the extent necessary to confirm or deny that an individual has complied with ignition interlock device installation and maintenance requirements.(j) This section shall become operative on January 1, 2019.(k) This section shall remain in effect only until January 1, 2026, and as of that date is repealed.Added by Stats 2016 ch 783 (SB 1046),s 22, eff. 1/1/2017.