19 Va. Admin. Code § 30-70-340

Current through Register Vol. 41, No. 4, October 8, 2024

Section 19VAC30-70-340 - Motorcycle brakes

A. The inspector, if qualified to operate a motorcycle, must drive it into the inspection lane and test the service brakes. If not qualified to operate motorcycles, the inspector must observe the operator operate the brakes. The inspector is required to observe and inspect the braking system on both wheels if so equipped or required to be equipped.

B. Inspect for and reject if:

1. Any motorcycle is not equipped with a brake, or which has a disconnected brake.

2. Any motorcycle which was originally equipped with a service brake system on both the front or rear wheel(s) if the service brake system has been altered by removing or disconnecting any of the brake system components from any of the wheels.

3. Any motorcycle manufactured after July 1, 1974, is not equipped with either a split service brake system or two independently actuated service brake systems which shall act on the front as well as the rear wheel or wheels.

4. Bonded linings or disc pads are worn to less than 2/32 of an inch in thickness or riveted linings or disc pads are worn to less than 2/32 of an inch over the rivet head(s).

5. Any lining is broken or cracked so that the lining or parts of the lining are not firmly attached to the shoe or disc pad.

6. Grease or any other contamination is present on the brake lining, disc pad, drum or rotor.

7. Rivets in riveted linings or disc pads are loose or missing.

8. A brake drum or brake disc (rotor) is scored to the extent that it impairs the braking system.

9. A brake drum or brake disc is worn beyond the manufacturer's recommended limit. (A brake drum or brake disc shall under no circumstances be re-machined beyond the manufacturer's specifications.)

10. Rods are bent, cotter keys or lock nuts are missing, cables frayed or broken or parts misaligned.

11. When operated at 20 miles per hour on a dry, level, hard surface free from loose material, the brakes will not stop the motorcycle within 30 feet.

12. Levers (foot and hand) do not have at least 1/3 of their travel as reserve after brakes are fully applied.

13. Any leaks in master cylinder, wheel cylinders, or any brake hoses or lines.

14. A motorcycle that is equipped with a front and rear master cylinder, if one or both are not displaying the recommended manufacturer fluid level.

15. Any line or hose not installed so as to prevent damage or abrasion by contact with the frame or other components. There is any leakage in any hydraulic, air, or vacuum lines; hoses have any cracks, crimps, restrictions, or are abraded exposing fabric; tubing or connections leak, are crimped, restricted, cracked or broken; any valves leak or are inoperative. Reject the vehicle if the brake hoses or tubing are stretched or extended and do not allow for suspension movement. Brake tubing and hoses must:

a. Be long and flexible enough to accommodate without damage all normal motions of the parts to which it is attached;

b. Be secured against chaffing, kinking, or other mechanical damage; and

c. Be installed in a manner that prevents it from contacting the vehicle's exhaust system or any other source of high temperatures.

19 Va. Admin. Code § 30-70-340

Derived from VR545-01-07 § 34, eff. May 1, 1990; amended, Virginia Register Volume 10, Issue 8, eff. February 9, 1994; Volume 21, Issue 4, eff. September 22, 2004; Volume 24, Issue 8, eff. March 1, 2008; Volume 28, Issue 24, eff. August 1, 2012; Amended, Virginia Register Volume 32, Issue 24, eff. 10/3/2016.

Statutory Authority: § 46.2-1165 of the Code of Virginia.