Current through Register Vol. 54, No. 45, November 9, 2024
Section 175.172 - Steering(a)Condition of steering components. The steering assembly and steering mechanism shall be in safe operating condition as described in § 175.190 (relating to inspection procedure).(b)Steering head. The steering head shall be provided with a bearing or similar device allowing the steering shaft to turn freely in a rotating fashion.(c)Handlebars. Nothing in this subchapter prohibits a motor-driven cycle or pedalcycle from being equipped with a steering wheel instead of handlebars.(1) The handlebars or steering system shall be of a sturdy construction adequate in size and length to provide proper leverage for steering and capable of withstanding a minimum force of 100 pounds applied to each handle grip in any direction.(2) The handlebars or steering system shall be designed so as not to restrict front fork movement and shall be capable of vertical adjustment.(3) The handlebar design shall provide a minimum of 18 inches between ends, after final assembly.(4) The handlebars shall be equipped with grips of nonslip design and materials.The provisions of this §175.172 adopted December 8, 1978, effective 12/9/1978, 8 Pa.B. 3495; effective date delayed April 28, 1979, 9 Pa.B. 1402; amended October 29, 1982, effective 2/1/1983, 12 Pa.B. 3862; corrected November 12, 1982, effective 2/1/1983, 12 Pa.B. 3947; readopted December 2, 1988, effective 12/3/1988, 18 Pa.B. 5362; amended November 13, 1998, effective 5/13/1999, 28 Pa.B. 5670; amended October 25, 2013, effective 10/26/2013, 43 Pa.B. 6349.The provisions of this §175.172 amended under the Vehicle Code, 75 Pa.C.S. §§ 4103, 4301, 4501, 4521 and 6103.