Current through Register Vol. 54, No. 45, November 9, 2024
(a)Condition of glazing. Glazing shall meet the requirements of Chapter 161 (relating to glazing materials). See 75 Pa.C.S. § 4526 (relating to safety glass).(b)Safety glazing. A vehicle specified under this subchapter shall be equipped with safety glazing in all windshields, windows and wings. The requirements of this subsection do not apply to a vehicle manufactured or assembled before January 1, 1934, if the original glazing is not cracked or discolored.(c)Stickers. Stickers shall be located as follows: (1) Truck weight classification sticker-trucks only-shall be affixed to lower left hand corner of the windshield to the immediate right of the certificate of inspection.(2) The following stickers are authorized to be affixed to windshield or windows, as indicated: (i) Out-of-State inspection stickers, tax stamps, road use permits or other government-related permits-municipalities and states-may be placed at the lower left or right-hand corner of the windshield.(ii) A Delaware River Port Authority Bridge Travel Permit may be affixed to the left rear window. This permit is 2-1/4 inches by 4-1/4 inches and is an automatic triggering device for passing vehicles through toll gates on a bridge.(iii) The suggested manufacturer's retail price sheet may be affixed to a new vehicle of a dealer. These labels are permitted only on the lower portion of a side window, as far to the rear of a vehicle as possible. When the vehicle is sold, this label shall be removed.(d)Obstructions. A vehicle specified under this subchapter shall have glazing free from obstructions as described in § 175.80 (relating to inspection procedure).(1) With the exception of materials in paragraph (4), signs, posters or other materials whose design prevents a driver from seeing through the material may not be placed on the windshield, a side wing, a side window or rear window so as to obstruct, obscure or impair the driver's clear view of the highway or an intersecting highway. Under FMVSS No. 205, these restrictions do not apply to the rear side windows, rear wings or rear window of trucks or multipurpose passenger vehicles.(2) With the exception of materials in paragraph (4), signs, posters or other materials whose design prevents a driver from seeing through the material may not be placed on a rear side window, rear wing or rear window of a passenger car which either covers more than 20% of the exposed portion of the windows or wings, or extends more than 3 1/2 inches above the lowest exposed portion of the windows or wings.(3) This subsection also applies to glass etchings, except those used for vehicle identification.(4) A sun screening device or other material which does not permit a person to see or view the inside of the vehicle is prohibited, unless otherwise permitted by FMVSS No. 205, or a certificate of exemption has been issued in compliance with § 175.265 (relating to exemption provisions). See Table X for specific requirements for vehicles subject to this subchapter. Passenger car requirements relating to the rear window are delineated by vehicle model year in Table X.(5) Vehicles specified under this subchapter may not have an obstruction forward of the windshield which extends more than 2 inches upward into the horizontally projected vision area of the windshield with the exception of windshield wiper components.The provisions of this §175.67 adopted October 29, 1982, effective 2/1/1983, 12 Pa.B. 3862; corrected November 12, 1982, effective 2/1/1983, 12 Pa.B. 3947; readopted December 2, 1988, effective 12/3/1988, 18 Pa.B. 5362; amended September 27, 1996, effective 9/28/1996, 26 Pa.B. 4640; amended November 13, 1998, effective 5/13/1999, 28 Pa.B. 5670.The provisions of this §175.67 amended under the Vehicle Code, 75 Pa.C.S. §§ 4103, 4301, 4501, 4521, 4524 and 6103.
This section cited in 67 Pa. Code § 175.80 (relating to inspection procedure).