N.J. Admin. Code § 7:27-6.2

Current through Register Vol. 56, No. 18, September 16, 2024
Section 7:27-6.2 - Standard for the emission of particles
(a) No person shall cause, suffer, allow or permit particles as measured by the performance test principles set forth in section 3 of this subchapter to be emitted from any source operation, except as provided in subsection (b) of this section, through any stack or chimney into the outdoor air in excess of the maximum allowable emission rate as determined below:
MAXIMUM ALLOWABLE EMISSION RATE FOR PARTICLES
1234
PotentialAllowableSource Gas EmittedAllowable
Emission RateEmission Ratefrom Source OperationEmission Rate
from Source(lbs. per hr.)(Standard cu. ft.(lbs. per hr.)
Operation (lbs.Based on 99%per min.)Based on 0.02
per hr.)efficiency ofgrains per SCF.
Collection.
50 or less0.53,000 or less0.5
1001.06,0001.0
100010.035,0006.0
200020.070,00012.0
3000 or greater30.0140,00024.0
175,000 or greater30.0
Instructions:
1. From columns 1 and 2 above, determine the allowable emission rate based
upon the potential emission rate of particles from the source operation as
measured by the performance test principles set forth in subsections 3(a)
and 3(b) of this subchapter;
2. From columns 3 and 4 above, determine the allowable emission rate based
upon the source gas emitted from the source operation. Whenever dilution
gas is, for any purpose, added to the source gas from a source operation,
the source gas emitted shall be considered to be the gas discharge rate
prior to such dilution;
3. The greater of the two emission rates as determined from 1 and 2 above
shall be the maximum allowable emission rate. For rates between any two
consecutive values stated in columns 1 and 3, the corresponding allowable
emission rates shall be as determined by interpolation.
(b) The provisions of subsection (a) of this section shall not apply to any glass manufacturing furnace. Such furnace(s) shall be subject to the following:
1. No person shall cause, suffer, allow or permit particles as measured by the performance test principles set forth in section 3(a) and (b) of this subchapter to be emitted from any glass manufacturing furnace through any stack or chimney into the outdoor air in excess of the maximum allowable emission rate, as determined from the equation below:
i.A=5 + (.48 x W);
ii.A=maximum allowable emission rate (lbs. per hr.);
iii.W=process weight per hour (tons per hr.).
(c) The provisions of subsection (b) of this section and section 5(b) of this subchapter shall not apply to any glass manufacturing furnace used for the production of lead glass.
(d) No person shall cause, suffer, allow or permit particles to be emitted from any stack or chimney into the outdoor air the shade or appearance of which is greater than 20 per cent opacity, exclusive of visible condensed water vapor.
(e) The provisions of subsection (d) of this section shall not apply to particles the shade or appearance of which is greater than 20 per cent opacity, exclusive of visible condensed water vapor, for a period of not longer than three minutes in any consecutive 30-minute period.
(f) If a paint spray operation meets the definition of a significant source operation under N.J.A.C. 7:27-8 or 22, as applicable, and the operation is constructed, reconstructed, installed, or modified on or after March 31, 1991, the operation shall, at a minimum, be served by particulate control apparatus.

N.J. Admin. Code § 7:27-6.2

Petition for Rulemaking: Exxon Company petitioned for change to the allowable particle emission rate limit.
See: 25 New Jersey Register 1577(c).
Petition for Rulemaking: Petitioners Exxon Corp. and Tosco Corp. sought to lift cap of 30 pounds of particulates per hour;
petition granted and amendment to rule to be completed.
See: 24 New Jersey Register 1577(c), 25 New Jersey Register 1893(b).
Amended by R.1998 d.231, effective 5/4/1998 (operative June 12, 1998).
See: 29 New Jersey Register 3521(a), 30 New Jersey Register 1563(b).
Added (f).